|
HYGRASREG® RH - 2Mechanical HYGRASREG® RH - 2 room hygrostat with switching output (with single-pole micro-switch for use as two-position controller with humidity sensor). The device operates without external voltage and features a humidity measuring element made of stabilized plastic fabric plus an optional setpoint setter for switchpoint adjustment (external or internal setting). It has an elegant plastic housing with snap-on cover, base with 4-hole attachment for mounting on vertically or horizontally installed in-wall flush boxes, with predetermined breaking point for on-wall cable entry. The RH - 2 device has been designed for use as a minimum or maximum hygrostat for controlling and monitoring the relative humidity in office and residential rooms, bathrooms, laboratories, control cabinets, computer rooms, etc. It is used in dust-free, unpolluted, non-aggressive air.
Collect
产品编号 1202-40C0
Switching capacity (Contact load) 24 V AC/ DC Dehumidifying: 5 (0.2) A, min. 100 mA Humidifying: 3 (0.2) A, min. 100 mA Operating difference approx. 4 % r. H. Contact 1 changeover contact, (potential-free) Setting range 25...95 % r. H. Sensor element plastic fibres Electrical connection 0.14 - 2.5 mm² via terminal screws on circuit board Housing plastic, material ABS, colour pure white (similar to RAL 9010) Housing temperature 0...+40 °C Dimensions 98 x 98 x 39 mm (Baldur 2, with Potentiometer) Installation wall mounting or on in-wall flush box, Ø 55 mm, base with 4 holes, for attachment to vertically or horizontally installed in-wall flush boxes for rear cable entry, with predetermined breaking point for cable entry from top/ bottom in case of plain on-wall installation Tolerance max. 3 % r. H. Protection class III (according to EN 60 730) Protection type IP 30 (according to EN 60 529) Standards CE conformity, EMC directive 2014/ 30/ EU, low-voltage directive 2014/ 35/ EU Sensor element Kunststofffasern Function humidifying: wire terminals 1 and 3 dehumidifying: wire terminals 1 and 2 |